1. Whats the meaning of this sign?
A. bump road
B. high outburst road
C. low-lying road
D. hump bridge
Answer: B
2. When the road maintenance vehicle and the engineering vehicle are on duty, the passing vehicles should avoid with care.
A. Right
B. Wrong
Answer: A
3. You can overtake from both sides in this case.
A. Right
B. Wrong
Answer: B
4. When a vehicle changes lane, the driver should turn on the turn signal in advance,observe traffic conditions, maintain a safe distance and move into the new lane.
A. Right
B. Wrong
Answer: A
5. What does this symbol indicate?
A. switch of high beam lights
B. switch of the low beam lights
C. master switch of vehicle lights
D. the switch of tail fog light
Answer: C
6. This set of the hand signals of the traffic police indicates that the vehicles should ___ .
A. turn left
B. wait to turn left
C. reduce speed and pass slowly
D. turn right
Answer: B
7. What does the traffic light mean?
A. no right turn
B. intersection warning
C. going straight is allowed
D. speed up and pass
Answer: B
8. It lights when the handbrake is pulled up.
A. Right
B. Wrong
Answer: A
9. This sign indicates indoor car park here.
A. Right
B. Wrong
Answer: A
10. Whats the meaning of this sign?
A. watch for animals
B. watch for wildlife
C. Wildlife Sanctuary
D. Large-scale farms
Answer: A
11. Whats the meaning of this sign?
A. no borrowing lane
B. no changing lane
C. no overtaking
D. no U turn
Answer: C
12. The contents of subject 2 test for small motor vehicle include Reversing stall parking, stopping at the appointed position and setting off on a slope, pulling over, driving by S-shaped line, sharp turning.
A. Right
B. Wrong
Answer: A
13. This small car can not stop here.
A. Right
B. Wrong
Answer: A
14. What is this manipulation device?
A. switch of reverse light
B. switch of wiper
C. switch of the hazard lights
D. combination switch of lights and signals
Answer: D
15. Whats the meaning of the marking in the red circle?
A. temporary stopping
B. bay-stopping
C. emergency stopping
D. public bus station
Answer: B
16. When driving at night, the driver should reduce speed and go forward if the vehicle coming in the opposite direction fails to turn off the high beam light. This is designed to prevent an accident from happening when there are pedestrians crossing the place where the lights of the two vehicles meet.
A. Right
B. Wrong
Answer: A
17. This sign reminds serious bump road ahead.
A. Right
B. Wrong
Answer: B
18. Rear fog light lights when the light switch is at this position.
A. Right
B. Wrong
Answer: A
19. How to run at this position when leaving the expressway?
A. enter the deceleration lane
B. keep running forward
C. keep the speed at 100km/hr
D. reduce the speed to less than 40km/hr
Answer: A
20. Driving on the expressway with full signs and marking, the driver should run in the lane and at the speed according to _________.
A. Signs and markings
B. Rules on road traffic safety
C. Vehicle manual
D. Local regulations
Answer: A